20MnB5 boric steel BBNsteel supplied for high-speed railway project

20MnB5 boric steel BBNsteel supplied for high-speed railway project

20MnB5 boric steel BBNsteel supplied for high-speed railway project

The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.

The cold working performance of 20MnB5 boric steel and so on steel structure engineering steel is good, which can ensure that the steel will not crack or brittle fracture during high-temperature processing, and will not have a great impact on strength, plasticity and toughness due to processing. The durability of 20MnB5 boric steel and so on steel structure engineering steel is good. Durability refers to the service life of steel structure. The main factor affecting the service life of steel is the poor corrosion resistance of steel, followed by the deterioration of mechanical properties of steel under long-term load, repeated load and dynamic load.

Preheating cutting: The most effective way to prevent steel plate cutting cracks is to preheat before cutting. Before flame cutting, the steel plate is usually preheated, and the preheating temperature mainly depends on the quality level and thickness of the steel plate. The preheating method can be carried out with flame burner, electronic heating pad, or heating furnace. In order to determine the preheating effect of the steel plate, the required temperature should be tested at the heating point.

In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.



Recently updated information