Alloy steel best 9 mills in Singapore
The qualified flat steel has sufficiently high high temperature strength and high temperature plasticity. Therefore, EN 10083-3 steel grades flat steel is not only required to have high enough normal temperature and instantaneous high temperature tensile strength and plasticity, but also long-term strength and long-term plasticity to ensure long-term safe work at high temperatures, especially under creep leakage conditions. The product thickness is 8-50mm, width 150-625mm, length 5-15m。
Large-thickness EN 10083-3 steel grades, Z35 grade steel plate is a kind of extra-thick steel plate that is applied under specific environmental conditions, such as the key parts such as the turbine seat ring and guide vane of the generator set. It has high requirements for safety, reliability, and long service life. Develop 200mm-300mm thick steel plate of Z35 level, to ensure that the layer tear resistance reaches Z35 level. 300mm thick Z35 grade steel plate can be used not only in the hydropower industry, but also in the manufacture of other large key equipment, and has broad prospects.
Titanium microalloying is an element of EN 10083-3 steel grades strengthening complex with carbon and nitrogen. The addition of micro amount of titanium in the steel can fix almost all nitrogen and part carbon in the steel, so as to eliminate the strain aging phenomenon and improve the aging impact performance of the steel. At the same time, it can refine the grains and change the morphology of the compounds. According to the atomic weight ratio of Ti and N in EN 10083-3 steel grades tin formula (Ti = 3.4n), the content of Ti in steel should be controlled between 0.015 and 0.025%. Generally, the amount of ferrotitanium added to each ton of steel is 1kg.
When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.