What is the alloy 50CrMo4 tensile test for fastener

What is the alloy 50CrMo4 tensile test for fastener

What is the alloy 50CrMo4 tensile test for fastener

We can process the steel materials according to your drawing. Or if you can not make drawing, please send us 50CrMo4 tensile test for fastener specific data and requirements, our technical department can make design and drawing for you, and then confirm with your technician or engineer. If all is OK, our processing center will process the steel materials according to the drawing. So no matter what size and shapes you need, we can meet demands at the most time.

Special boiler steel is derived from carbon structural steel, 50CrMo4 tensile test for fastener. The expression of boiler steel grade is similar to that of high-quality carbon structural steel, and the carbon content is usually 0.20%. The chemical composition of boiler steel is basically the same as that of high-quality carbon structural steel of the same brand, but the mechanical properties are strictly required, especially the impact toughness, and the aging sensitivity is required to be small. After deoxidation and removal of non-metallic inclusions, boiler steel has a uniform structure, the grain size is controlled at 3-7 grade, and the defects such as interlayer, shrinkage, porosity and porosity are relatively less.

50CrMo4 tensile test for fastener, 09CuPCrNi-A weather resistant steel is origined in China. Its equivalent grades are JIS SPA-H, BS WR50A, Corten steel, etc. The Cu, P, Cr, Ni are important elements that gave 09CuPCrNi-A weather resistant steel its weathering ability. The Cu content of 09CuPCrNi-A steel is 0.25–0.50, P content is 0.060-0.12, Cr content is 0.30-1.25, Ni content is 0.12-0.65. For 09CuPCrNi-A steel coil ≤ 4mm, the min. yield strength is 310Mpa, min. tensile strength 440Mpa. For 09CuPCrNi-A steel sheets >4mm, the min. yield strength is 345Mpa, min. tensile strength 480Mpa.

The results of adopting two-level 50CrMo4 tensile test for fastener service system and implementing standardized management are mainly reflected in the formation of vigorous work style such as quick response and quick action. Our company's customer service center stipulates that employees must be accurate and quick in technical support and 50CrMo4 tensile test for fastener after-sales service. Through the formation of this fast, agile, vigorous style, to provide users with satisfactory service.



Recently updated information